Close menu
Navigation
Back to main menu

Design, Supply & Installation

Underfloor Heating Design & Installation in Droitwich & Worcestershire

We design and install wet underfloor heating across Droitwich, Worcester and the wider Worcestershire area - for new builds, extensions and retrofits in existing properties. That means the full job: heat loss calculations, pipe layout design, manifolds, zoning, controls, commissioning and balancing.

Design is the part that gets skipped most often, and it's the part that determines whether the system actually works. Pipe spacing, flow rates and zoning have to be calculated for each room, not laid out by eye. Once the screed is down there's no adjusting it.

Call us now on:

07511 233641

Accredited & Approved

Why Choose Underfloor Heating?

  • Even heat. A large radiant surface warms a room evenly, rather than creating hot spots near radiators and cold corners elsewhere.
  • No radiators. Wall space back, and nothing dictating where furniture goes - often the deciding factor in a kitchen extension or a bathroom.
  • Lower flow temperatures. Underfloor heating runs at around 35–45°C rather than the 65–75°C a radiator system needs, which is more efficient with a modern condensing boiler and considerably more so with a heat pump.
  • Comfortable underfoot, particularly on tile and stone floors that otherwise feel cold.
  • Quiet and invisible. No expansion ticking, nothing on the walls.

Balance

Worth knowing the trade-offs too: it responds more slowly than radiators, so it suits steady running rather than quick bursts of heat. Retrofitting into an existing floor adds height, which affects doors and thresholds. And it's more expensive to install than radiators, though it usually costs less to run. We'll set all of that out before you commit.

Wet vs Electric Underfloor Heating

Wet systems circulate warm water through pipes in the floor, fed by your boiler or heat pump. Electric systems use heating mats laid under the floor covering. They suit quite different jobs.

We install wet systems. They cost more upfront but are substantially cheaper to run, which makes them the right choice for whole rooms and whole houses - and they're the only option that works with a heat pump. Electric mats make sense for a single small bathroom where running a water circuit isn't practical, but running costs make them expensive for anything larger.

If you're weighing the two up for a specific room, tell us the situation and we'll give you a straight answer, even if it's that a wet system isn't worth it for that particular job.

New Builds, Extensions & Retrofits

New Builds & Extensions

The easiest scenario. Pipes are laid over insulation and set into the screed before the floor covering goes down, so there's no height issue and no compromise on layout. We work with self-builders and contractors across Worcestershire, and the earlier we're involved the better - floor build-up, insulation depth and manifold position are all much easier to get right at design stage than after the slab is poured.

Retrofitting an Existing Property

Harder, but very often achievable. Low-profile systems add far less height than traditional screed - usually a matter of tens of millimetres - which is frequently manageable with some adjustment to doors and thresholds. Suspended timber floors can have pipes fitted between the joists from below or above depending on access. We'll look at the floor construction and tell you honestly what's practical and what it would involve.

Underfloor Heating and Heat Pumps

These two go together better than almost any other combination in domestic heating. A heat pump is most efficient at low flow temperatures, and underfloor heating is designed to run at exactly those temperatures - where a radiator system asks a heat pump to work considerably harder for the same result.

We're MCS certified as well as being underfloor heating installers, so we can design both together as a single system rather than fitting one and hoping it suits the other. If you're planning an extension or a renovation and considering a heat pump at any point in the next few years, it's worth designing the underfloor heating for it now - it costs very little extra at the time and saves a great deal later.

Find out more about Air Source Heat Pumps

Which Floor Coverings Work?

Most work, but they don't perform equally:

  • Tile and stone - the best conductors and the most responsive. The obvious choice for kitchens and bathrooms.
  • Engineered wood - works well, provided it's rated for underfloor heating and the manufacturer's maximum surface temperature is respected.
  • Solid wood - possible but needs care. Movement with temperature change is the risk, so board width and acclimatisation matter.
  • Vinyl and LVT - generally fine, with a temperature limit worth checking.
  • Carpet - works, but the combined tog rating of carpet and underlay needs to stay low. Thick underlay effectively insulates the floor from the room.

Tell us what you're planning to put down and we'll factor it into the design. It affects pipe spacing and flow temperature, so it's better known upfront than discovered afterwards.

OUR DESIGN & INSTALLATION PROCESS

Plans and requirements

Drawings if you have them, or a visit if you don't. We'll want to know the floor construction, insulation and intended floor coverings.

1

Heat loss calculations

Room by room. This determines pipe spacing and flow rates - it's the difference between a system that heats the room and one that doesn't quite.

2

Design and quote

Pipe layouts, manifold position, zoning and controls, with an itemised price.

3

First fix

Insulation, pipework and manifold installed and pressure-tested before the screed goes down. We coordinate with your builder or screeder on timings.

4

Second fix and commissioning

Controls wired, system filled, balanced and set up.

5

Handover

We show you how it runs - underfloor heating is set up differently from radiators, and knowing that from the start avoids a cold first winter.

6

Areas We Cover

We design and install underfloor heating across Droitwich Spa, Worcester, Redditch, Kidderminster, Bromsgrove, Malvern, Pershore and the surrounding Worcestershire villages - for homeowners, self-builders and contractors.

See all areas we cover

Get in touch

Talk to Us About Your Project

Whether it's a single room, an extension or a whole house, the earlier we're involved the better the result. Send us your plans or give us a call and we'll talk through what's practical and what it would cost.

Call us now on:

07511 233641

Made & Marketed by
Websites for Tradespeople x Marketing for Tradespeople
keyboard_arrow_up